SMD5730 SMD LED lamp beads Products: □ □ Application Features in power, high brightness LEDs advertising signs light angle LCD backlight low impedance models wafer Lens Color 5730 White Material luminous colors white yellow transparent indium gallium nitride maximum rated the value of T = 25 ℃ Parameter (parameter) Valce (standard value) Unit (Unit) Power Dissipation (power consumption) 300 mW Pulsed Forward Current (pulsed forward current) (1/10 Duty Cycle, 0.1ms Pulse width 200 mA Continuous Forward Current (continuous current) 150 mA Derating Linear From 50 ℃ (current proportional relationship) 0.4 mA / ℃ Reverse Voltage (reverse voltage) 5 V Operation Temperature Range (operating temperature) -40 ℃ to + 80 ℃ Storage Temperature Range (Storage temperature) -40 ℃ to + 80 ℃ Lead Soldering Temperature [4mm (.157 ") From Body] under (soldering temperature) 260 ℃ for 5 Seconds (260 degrees no more than 5 seconds) Electrical Characteristics T = 25 ℃ Parameter Symbol Min flag . Min Typ. Max Max intermediate values. Unit Unit Test Condition Test conditions Luminous Intensity (light intensity) IV 10000 13500 15000 mcd IF = 150mA Note 1 Viewing Angle (light-emitting angle) 2θ1 / 2 110 120 130 deg Note 2 Chromaticity Coordinate (R) (color temperature) CCT 5000 - 5500 K IF = 150mA Note4 Forward Voltage (R) (forward voltage) VF 3.0 3.2 3.4 V IF = 150 (mA) Reverse Current (reverse current) IR - - - 5 μA VR = 5V Notes: 1. The luminous intensity is a measure of a light sensor and filter combination approximate CIE chromaticity diagram curve (Commission on International L'lighting) 2. half-power angle is the luminous intensity is half of the shaft. the luminous intensity. 3. dominant wavelength, λd is derived from the CIE chromaticity diagram and define the color of a single wavelength devices. The brightness of the error range of ± 15%. Characteristic curves Relative Spectral Emission V (λ) = Standard eye response curve Φrel = f (λ); TA = 25 ° C; IF = 150mA Radiation Characteristic Φrel = f (?); TA = 25 ° C Forward Current IF = f (VF); TA = 25 ° C Relative Luminous Intensity IV / (150mA) = f (IF); TA = 25 ° C Chromaticity Coordinate Shift x, y = f (IF);. TA = 25 ° C Max Permissible Forward Current IF = f (T) Reflow 1. This product can only be up to twice reflow and after reflow should be cooled before the first second after reflow to room temperature. 2. High temperature soldering, not external pressure . LED on .. 3. After welding is completed, you can not bend the board a> leaded reflow 2> Lead-Free Solder (Pb-free reflow) Tape Specifications (loading specifications) (Unit: mm) Emitter Reel Packaging (Packaging disc) Recommended Soldering Patter (n Recommended land pattern) (Unit: mm)